Video

General discussion about the sport of hang gliding
Steve Davy
Posts: 1338
Joined: 2011/07/18 10:37:38 UTC

Re: Video

Post by Steve Davy »

"Bent pin release - Poor ratio [Load]/[Actuation effort]"

http://www.youtube.com/watch?v=ilrlUT6RHjg
Steve Davy
Posts: 1338
Joined: 2011/07/18 10:37:38 UTC

Re: Video

Post by Steve Davy »

Steve Davy
Posts: 1338
Joined: 2011/07/18 10:37:38 UTC

Re: Video

Post by Steve Davy »

James Yocum - 27723
- H4 - 1987/09/20 - R. Annis - AT FL AWCL CL FSL RLF TUR XC - AT ADMIN, EXAM, OBS
- P2 - 1995/02/15 - William Laurence

1:55

http://vimeo.com/53878203
Aerotowing, Hang Gliding and Dogs
Ann Dunlap - 2012/11/19 13:42
dead
Steve Davy
Posts: 1338
Joined: 2011/07/18 10:37:38 UTC

Re: Video

Post by Steve Davy »

More good stuff from Ann:

http://vimeo.com/101528261
Scooter Towing at Markham's 28 June 2014
Ann Dunlap - 2014/07/23 11:08
dead

http://vimeo.com/103681010
Villa Grove 17 August 2014
Ann Dunlap - 2014/08/18 00:22
dead
Steve Davy
Posts: 1338
Joined: 2011/07/18 10:37:38 UTC

Re: Video

Post by Steve Davy »

Steve Davy
Posts: 1338
Joined: 2011/07/18 10:37:38 UTC

Re: Video

Post by Steve Davy »

"Hang Glider Crash in Sting 3"

http://vimeo.com/101206617
http://vimeo.com/101206617
Steve Davy
Posts: 1338
Joined: 2011/07/18 10:37:38 UTC

Re: Video

Post by Steve Davy »

Steve Davy
Posts: 1338
Joined: 2011/07/18 10:37:38 UTC

Re: Video

Post by Steve Davy »

http://www.youtube.com/watch?v=PYi_0yLKDr8


Hang Gliding - Mis-assembled Control Frame Incident - Dog Mtn, WA 3/15/14
Eric Troili a.k.a. AirWreck - 2014/03/19

Easy, 30-second solution - This video is in response to the control frame mis-assembly incident at Dog Mountain on 2014/03/15.. The improper assembly of the control frame was not immediately apparent to the pilot during preflight.. The control bar was not fully seated into the corner-bracket; then rig pin was fully installed through the installation holes in the bracket.. But since the control bar was not fully seated in the corner-bracket, the rig pin did not pick-up the installation holes in the base tub leaving the control bar essentially unattached..

Without an obvious visual cue to alert the pilot, the mis-assembled control frame gave the appearance of proper assembly.. Immediately after the glider was airborne the mis-assembled control frame failed at the corner-bracket and the pilot miraculously directed the gilder to a decent landing near the regular landing area..
User avatar
<BS>
Posts: 422
Joined: 2014/08/01 22:09:56 UTC

Re: Video

Post by <BS> »

http://www.youtube.com/watch?v=2dvr9P_w5VQ
Hang gliding - Dan explains the double-threaded tow bridle system
jwm239 - 2011/05/02
dead
Steve Davy
Posts: 1338
Joined: 2011/07/18 10:37:38 UTC

Re: Video

Post by Steve Davy »

Post Reply